Wavlink Quantum D4G SETUP

You can connect the Wavlink quantum d4g Extender setup to your wireless network or modem by following the setup directions. Using a WiFi booster can help your current wireless network's signal get stronger and guarantee continuous connectivity to distant devices.

Wavlink Quantum D4G Mesh Extender Setup-Manual Guide

1. After taking it from its packaging, insert the extender into the outlet.
2. Once the LED power light turns green, press the button for power.
3. Connect your WiFi device to the _Ext network of the Ap extender setup.
4. Now enter Ap.Setup into the browser of your choice.
5. This is the Wavlink AC1200 extender's configuration page.
6. Create an AP Login account and then follow the guidelines.

Note:- If you need any help regarding your wavlink wifi extender setup so contact with our technicain or visit the official website that is Brostrend extender setup.

Wavlink Quantum D4G Wifi Range Extender Setup-WPS Guide

1. Connected to your router, plug in the Wavlink Quantum D4G extender.
2. The WPS button on the extender should be pressed.
3. Within two minutes, press the WPS button.
4. Hold off until the extender's WPS LED solidifies, indicating a successful connection.
5. Within the router's coverage area, move the extender to the desired spot.
6. For greater coverage, connect your devices to the extended WiFi network.

Wavlink Quantum D4G Extender-Login

1. Make sure your device is connected to the WiFi network of the Wavlink Quantum D4G extender.
2. Enter "ap.setup" in the address bar of an open web browser.
3. To access the login screen, enter the default password and username.
4. Change the extender's settings as required.
5. After making changes, log off of the admin area.

Firmware update Wavlink Quantum D4G Extender

1. To access the admin interface of the extender, connect to its WiFi network.
2. Enter your login information to log in.
3. Go to the Settings > Firmware Update section.
4. Get the most rare uploaded firmware by visiting Wavlink's website.
5. Firmware files are uploaded to the extender.
6. Start the updating procedure and give it time to finish.

Wavlink Quantum D4G Reset Process

1. Find the Wavlink Quantum D4G extender's reset button.
2. A paperclip or other similar item should be used to press and hold the reset button for 10 seconds.
3. The moment the LED lights start to blink, release the button.
4. Wait for the reboot of the extender.
5. Change the settings of the extender as required.

---