Cord E-1
| Cord E-1 | |
|---|---|
1932 Cord E-1 | |
| Overview | |
| Manufacturer | Cord Automobile |
| Production | 1932 |
| Model years | 1932 |
| Body and chassis | |
| Class | Ultra-luxury car |
| Body style | 4-door limousine |
| Layout | Front-mid-engine, rear-wheel-drive layout |
| Powertrain | |
| Engine |
|
| Transmission | 3-speed manual transaxle |
| Dimensions | |
| Wheelbase | 157 in (3989 mm) |
| Curb weight | 6,000 lb (2,700 kg) |
| Chronology | |
| Predecessor | Cord L-29 |
| Successor | Cord 810/812 |
The Cord E-1 is a luxury automobile that was produced by the Cord Automobile division of the Auburn Automobile Company in 1932. Intended as a larger successor to the Cord L-29, the E-1 was designed as an ultra-luxury limousine with an exceptionally long wheelbase and a powerful V12 engine. Due to global financial crisis this car never entered into full production.[2] Engineered during the lowest economic point of the Great Depression, the E-1 was a massive mechanical showcase, built on an unprecedented 157-inch wheelbase and weighing over 6,000 pounds. Originally drawn to house a monumental 16-cylinder engine, it was ultimately completed with an experimental 491-cubic-inch V12. Due to the collapsing market for ultra-luxury automobiles, the project was canceled before entering serial production, leaving behind a legacy as one of the most ambitious engineering prototypes of the pre-war era.
Dvelopment
In the early 1930s, E. L. Cord envisioned a new range of luxury vehicles to follow the Cord L-29. The E-1 was designed as a significantly larger automobile, with a wheelbase stretched by 20 inches compared to the L-29, resulting in a 157-inch (3,989 mm) wheelbase. The vehicle was planned as an enclosed limousine-style sedan intended for the 1932 model year. Originally engineers considered fitting the car with a Miller's 16-cylinder engine to power its substantial size, which would have made it larger and more opulent than even a long-wheelbase Duesenberg.[3] This plan was abandoned in favor of a prototype 491 cubic inch (8.0 L) V12 engine producing approximately 200 horsepower. Company records indicate that three sedans were built in August 1932 as part of the experimental program, though the E-1 is the primary surviving and documented example.
The completed prototype weighed 6,000 pounds (2,700 kg) and featured front-engine, rear-wheel-drive layout (distinct from the L-29's front-wheel drive).
Engineering and Design
Chassis and Powertrain
The E-1 pushed the technical limits of front-wheel-drive geometry. The chassis was underpinned by a heavy-gauge steel frame designed to counter the extreme torque load of its forward-mounted powerplant. To balance the immense weight, the vehicle preserved the transaxle-forward packaging popularized by the L-29.
| Parameter | Technical Specification |
|---|---|
| Engine Architecture | 491.0 cu in (8.0 L) experimental 60-degree V12 |
| Horsepower Output | 200 hp (147 kW) |
| Drivetrain Layout | Front-engine, front-wheel-drive (FF layout) |
| Transmission | Heavy-duty 3-speed manual transaxle |
| Wheelbase | 157.0 inches (3,988 mm) |
| Total Curb Weight | Estimated in excess of 6,000 lbs (2,722 kg) |
Aesthetics and Coachwork
The lone completed body was configured as a formal, closed-roof luxury limousine. Because the front-wheel-drive architecture completely eliminated the need for a rear differential hump, the floorboards sat extraordinarily low to the ground relative to its massive profile. The styling featured deep navy blue paintwork, sweeping full-skirted front fenders, dual side-mounted covered spare tires, and an upright, commanding chrome grille adorned with a specialized winged emblem. The interior compartment was opulently finished in fine tan broadcloth and premium leather.
Cancellation
The deepening Great Depression made the introduction of an ultra-luxury vehicle impractical. Plans to produce the E-1 were scrapped, as the market could not support a car positioned above even the prestigious Duesenberg models. Following cancellation, the prototype was dismantled. Its engine was reportedly repurposed for use in a local power plant dynamo, while the body was stored and eventually left in a barn near Plato Center, Illinois.[4]
Rediscovery and Restoration
For decades, the E-1 was believed to have been completely destroyed by the factory. However, the bare, surviving limousine body shell was discovered by car hunter Paul Bryant in a rural barn located near Plato Center, Illinois. When found, the historical artifact was missing its entire front clip: it possessed no engine, no fenders, and no grille shell. Bryant launched a meticulous, multi-year archival search across the United States to recover the scattered components from the original three "EXPR" test mules. Through this effort, the original experimental V12 engine block and correct body panels were located and reunited. The reassembled, historically accurate vehicle is now fully restored and forms a centerpiece of the permanent collection at the Auburn Cord Duesenberg Automobile Museum in Auburn, Indiana.
Notes
1. The Curtiss Engine Myth: Certain early automotive folklore threads claimed the E-1 was built to house a liquid-cooled Curtiss V-12 aircraft engine. Museum records verified that the 491-cubic-inch V12 was entirely an in-house automotive development project conducted via Lycoming, a subsidiary of the Cord Corporation.
2. Survival Scope: While factory records indicate parts were produced for three experimental chassis units, only a single complete E-1 automobile was successfully reconstructed and exists today.
References
Bibliography
- Kimes, Beverly Rae (1996). Standard Catalog of American Cars 1805-1942. Krause Publications. ISBN 978-0873414289. Search this book on

- Malks, Josh B. (2010). Cord 810/812: The Timeless Classic. Automobile Quarterly Publications. ISBN 978-0971146815. Search this book on

Category:Cord vehicles
Category:Front-wheel-drive vehicles
Category:Cord vehicles
Category:Coupés
Category:Sedans
Category:1930s cars
Category:Cars introduced in 1932
| This vehicle-related article is a stub. You can help EverybodyWiki by expanding it. |
This article "Cord E-1" is from Wikipedia. The list of its authors can be seen in its historical and/or the page Edithistory:Cord E-1. Articles copied from Draft Namespace on Wikipedia could be seen on the Draft Namespace of Wikipedia and not main one.
